Our residential automated burner system is the ideal product for custom fire pits requiring safety shut-off and convenient electronic ignition start.   Package includes: Stainless steel burner, pan, control valve, and vinyl cover. 

 

Features:

     *       Thermocouple technology with reliable hot wire ignition suitable for outdoor conditions

     *        Fully assembled burner with pan lip for ease of installation

     *       16 gauge stainless steel components designed for use in harsh coastal environments

     *        Convenient gas and electrical connections provided at base of valve box
 

 

Specifications:

-          18" stainless steel fire ring (175,000 BTU’S)

-          Natural gas supply pressure: Minimum 5” W.C; Maximum 7” W.C)

-          Propane gas supply pressure: Minimum 10” W.C; Maximum 14” W.C)

-          Electrical: 110V required to valve box. 

-          Pan dimension: I.D 25”, pan lip 1 3/8”, O.D 27 ¾”, depth 2 ½”

-          Complete assembly  height: 12 ½” (6” minimum clearance required under valve box)

 

Warranty: 3 years on stainless steel burner, pan, and valve box. 1 year on electrical components

 

Planning & Design:

-          For use in outdoor approved locations only

-          Install proper size gas line based on BTU’s of appliance. Undersized gas line will result in inadequate flame appearance

-          Do not install corrugated or fluted gas lines or a whistling sound can occur.

-          Maintain proper clearances.   14” from sides surrounding fire pit, 96” above fire pit

-          Install on a stable surface

-          System includes a standard on/off switch which a qualified electrician can install. Consider integrating with pool electronics or install a remote control

-          Enclosure must incorporate two air vents. Minimum of 16” square inches on each side of pit

-          L.P burners must not be covered more than 1” with fire glass or crushed lava rock

-          Flame Creations, LLC offers a full line fire pit frames designed to accept burner assembly

Installation collar is now available.  The collar should be installed into the enclosure while it is being built.  Collar must be installed at least 16" up from bottom of enclosure.   The I.D and O.D of collar differ by 6" to allow part of collar to be mortared in enclosure and at least 1" projected into enclosure for pan lip to overlap.   Call for custom sizes 770-335-2405