Features:
 *    Hot wire ignition suitable for outdoor conditions
 *    Fully assembled burner with pan support lip for ease of installation
 *   16 gauge stainless steel components
 *   Convenient gas and electrical connections provided at base of valve box 

 

Specifications & Technical:
-          Stainless steel fire ring (90,000 BTU’S)
-          Natural gas supply pressure:  Minimum 5” W.C; Maximum 7” W.C
-          Propane gas supply pressure:  Minimum 10” W.C; Maximum 11” W.C
-          Electrical: 110V required to valve box
-          Pan dimension: I.D 13”, pan lip 1 3/8”, O.D 15 ¾”, depth 2 ½”
-          Complete assembly height: 12 ½” (6” minimum clearance required under valve box)

Fire Glass & Lava Rock Application:
*  Natural Gas Burners -  Recommended media size:  Fire glass (1/4" - 2"), lava rock (2" or larger)
*  Liquid Propane (LP) Gas Burners:  Fire glass or crushed lava rock must not cover burner holes
*  LP Gas Warning:  Applying fire glass or crushed lava rock (2" or smaller) in excess of 1/4" on top of burner may result in unburned gas pooling in pan and within fire pit.
*  LP gas burners recommended media:  Large lava rock (2" or larger), lava rock boulders

 

Warranty: 3 years on stainless steel burner, pan, and valve box. 1 year on electrical components

 

Planning & Design:
-       For use in outdoor approved locations only
-       Install proper size gas line based on BTU’s of appliance. Undersized gas line will result in inadequate flame appearance
-       Do not install corrugated or ribbed gas lines.  Flexible gas line can result in a whistling sound during operation
-       Maintain proper clearances. 14” from sides surrounding fire pit, 96” above fire pit
-       System includes a standard on/off switch which a qualified electrician can install. 
-       Enclosure must incorporate two air vents. Minimum of 16” square inches on each side of pit
-     Enclosure may require more ventilation based on material, size and use
-       Flame Creation, LLC offers a full line fire pit frames designed to accept burner assembly
 
Accessories:
Installation collar is now available.  The collar should be installed into the enclosure while it is being built.  Collar must be installed at least 20" up from bottom of enclosure.   The I.D and O.D of collar differ by 6" to allow part of collar to be mortared in enclosure and at least 1" projected into enclosure for pan lip to overlap.   


All information provided is for general information only.  Designing, installing, and servicing of any gas burner and fire feature must be performed by a qualified professional and gas supplier.  Installations must conform to local codes or in the absence of local codes refer to the National Fuel Gas Code (ANSI Z223.1 or CAN/CGA 8149.1), National Fuel Gas Installation Code, Propane Installation Code or CAN/CGA B149.2